moparmike1974
Well-Known Member
- Joined
- Nov 12, 2018
- Messages
- 66
- Reaction score
- 12
Im looking for anyone who has installed an AMD firewall in their cuda or challenger that can give some tips on installing.
I started by clamping it from the top and working down. When I got to the bottom there is at lease 1/2" gap to the floor flange. So I pulled it and clamped the bottom and worked to the top. It almost wanted to go but couldnt quite make it. Next I started at the top and clamped it down, working my way to the bottom with the same results. All of curved are lining up on the hinge pillars like they should. It appears that the bottom part just does not extend down far enough.
Has anyone else run into this issue and if so what was the remedy?
I started by clamping it from the top and working down. When I got to the bottom there is at lease 1/2" gap to the floor flange. So I pulled it and clamped the bottom and worked to the top. It almost wanted to go but couldnt quite make it. Next I started at the top and clamped it down, working my way to the bottom with the same results. All of curved are lining up on the hinge pillars like they should. It appears that the bottom part just does not extend down far enough.
Has anyone else run into this issue and if so what was the remedy?