Shock tower measurements

[AUSTA]

Anyone have the shock tower hole to hole (shock Bolt) center measurements for a 70 Challenger

 

[Adam]

I will check tomorrow for you, if no one else replies.

 

[aussiemark]

Brian I've got 837mm or a tad under 33 inches, maybe someone else can confirm.

 

[aussiemark]

This may help

 

[AUSTA]

Thanks Mark have that but it does not show tower spacing.
All the heights & spacing between the rails are right ,it had a slight hit in the L/H front i think there is a slight twist towards the inside will wait for some more feedback before welding inner fender
I am at 34"

 

[Adam]

My engine valve covers are in the way so it is hard to be exact, but I got 33 & 7/8.

 

[AUSTA]

My engine valve covers are in the way so it is hard to be exact, but I got 33 & 7/8.

Thanks ADAM i made some large calipers to go over the engine on my original A66 comes up at 34 same as the TA i am restoring good to weld.

 

[aussiemark]

My measurement was from the centre of the shock shaft to the centre of the other one it may be different if measured from the centre of the shock shaft hole, where are you measuring from? You are more the welcome to come around and check both of my cars with your callipers.

 

[ED LUKACH]

I HAVE FRAME DEMISION CHART IT SHOWS HOLES ARE SAME AS CENTER TO CENTER OF FRAME RAILS THAT ARE 34" HOPE THIS HELPS ED
'

 

[AUSTA]

Thanks ED spot on