Small block windage tray

[btceng]

Trying to test fit a wind age tray in my 340 but the bolt holes are about 1/4" too wide. Is there a difference in small blocks? I am assuming that it's for a 360 and that the bigger crank caps are the issue. Is this a issue that can be cleared up by elongating the holes to fit? If not, anyone want to trade?

 

[bad440]

I'm betting you have a tray from an HP 360, the main bolts are spread further apart.

 

[Chryco Psycho]

I have never tried to move the bolt holes but the 360 crank would be bigger if anything so it should work OK

 

[btceng]

I looked online and see that the ones at Summit have the holes elongated. I'll try this on mine. Barely fits inside the pan flanges but I guess that's normal.

 

[Chryco Psycho]

I think the 360 tray is taller as well so it may interfere with the side of the oil pan