correct valve cover bolts 383 cuda

[cuda joe]

i have all anker bolrs on there now i have read it originally had studs in the corners . did it have the anker bolts at all are they correct if not what did they have

 

[Xcudame]

Studs in the four bottom corners and 8 each 1/4-20 x .50" bolts in the other locations. Six fasteners total per cover

 

[Xcudame]

See below picture.

 

[Steve340]

Mega Parts sells a bolt/stud kit.

 

[cuda joe]

thanks does anyone know where the short 1/4 20 anker bolts go

 

[pschlosser]

I'm not entirely sure what you have as an anker bolt. Maybe post an image, and we can help you figure where they go.

The fasteners shown in post #3 are the ones you want for the valve cover.

 

[DetMatt1]

This has nothing to do with the original question but a bolt without a nut is a screw, the book is fundamentally wrong…

 

[pschlosser]

A bolt fastens into a threaded opening, and a screw fastens to unthreaded materials.

 

[larry4406]

Is the bolt/stud info of this thread just for 383 engines?

 

[Xcudame]

383/400/413/426w/440 from 64 to 78. 59-63 the big block heads had only 4 bolts and no studs.

@DetMatt1 you are technically correct. What we call head bolts are actually screws, but it just doesn't sound right calling them head screws after folks calling the head bolts for over 125 years!