I loosen my steering column at the firewall and under the dash, when I removed my dash. After I reinstalled the dash, I noticed that my steering has some resistance when I turn the steering wheel, with the front wheels off the ground. I also noticed my horn goes off when I make a left or right turn. Is there a certain position the column bolts to the firewall so the steering shaft aligns with the steering box correctly? I noticed the mounting holes are pretty large. I have a Borgeson power steering unit. Sorry for the poor quality photos. I wasn't able to show all the location of all the mounting bolts in one photo. Thanks
Steering Column Position/Steering Resistance
- Thread starter money pit
- Start date
Challenger RTA
Well-Known Member
From what I see. It looks like the mounting flange moved up. I would move it back by lifting on the and tighten down. Or pull the flange back down and tighten down. There is a plastic retainer in the engine bay end. That allows the shaft to go of center.
I put a bearing in the end to hold it center.
SER205-16, ER205-16, ER-16 1" Bore Insert Bearing with Snap Ring 1"x52mm | eBay
I put a bearing in the end to hold it center.
Last edited:
Ronbo73
Well-Known Member
I noticed you stated the horn would go off when turning the wheel in either direction. Did you change the steering wheel or remove it to make more clearance when puling your dash? I would check the connection from the crush can to the horn switch under your horn button. The wire may be rubbing and grounding out which would trigger the horn to go off while turning your steering wheel.
Similar threads
