Correct stat?

[Oystercopy]

I just pulled my thermostat housing off the 440 (leaking) to replace the gasket. Found a 195 degree stat in there, which appears to be the correct temp for this application (1970 block).
Was advised that I may want to use a 160 stat instead, so that it will open sooner. I have had no issues with overheating, and - to the best of my knowledge - the stat was working properly.

Thoughts?

 

[Steve340]

No overheating - leave it alone.

 

[Chryco Psycho]

160* is too cold , use a 180* minimum or 195*
I agree with Steve but if you replace it use a good quality one such as Stant , not chinese junk .

 

[Oystercopy]

Thanks guys... I'm leaving it alone.